Hardware Requirements

• Any workstation

• Any NVIDIA Quadro graphics card with a 3-pin DIN connector

• NVIDIA 3D vision or equivalent

• Monitor with a refresh rate >= 100Hz

Software Requirements

• Viz Artist/Engine 3.3 or later

• The display must be set to a refresh rate >= 100Hz

To Set Up a 3D Working Environment

1. In the Windows video board 3D settings, Set Stereo - Enable to On.

2. Select the appropriate Stereo - Display mode for each stereo device.

   Note: For NVIDIA’s 3D Vision, this is ‘On-board DIN connector’.

   

3. In Camera settings (see the Configuring Viz section of the Viz Engine Administrator Guide) set Stereo Mode to Quad Buffered.

   

   Also it is possible to use an autostereoscopic monitor that supports sub-fields or side-fields, such as Miracube’s c190 series. The drawback with these displays is that you need to go On Air to get a full-screen image, which is halved in resolution.

See Also

• Camera Editor

• Stereo Settings

• Stereoscopy Best Practices

• Change Camera Parameters in Orthogonal Views

• Track Objects with a Camera

• Receive Tracking Data from a Real Camera

• Copy Properties from One Camera to Another

• Camera Selection

• Camera Animation