Viz Artist User Guide
Version 3.14 | Published October 30, 2020 ©
Graph
The Graph object allows you to create a 2D or 3D graph with up to 50 values.
Note: This plug-in is located in: Built Ins -> Geom plug-ins -> Default
Graph Properties
-
Use LOD: Enables/disables dynamic level of detail.
-
Width: Sets the width of the graph.
-
Height: Sets the height of the graph.
-
Start: Sets the starting point of the graph.
-
End: Sets the ending point of the graph.
-
Line Width: Defines the line width.
-
1st/last segment interpolation: Switches the interpolation of the first and last segment on or off.
-
3D: Enables/disables 3D visualization of the graph.
-
Extrusion depth: Sets the graph’s extrusion depth.
-
Add backside: Enables/disables visualization of the graph backside.
-
Use vertex color: Enables a base color for the graph. Set the values in the color editor or drag a material onto the small square below the parameter.
-
Line color: Enables the use of a vertex color.
-
X0/Y0 to X49/Y49: Enables up to 50 different value points of the graph by giving coordinates on the X- and Y-axis.
To Create a Graph
-
Create a new group and add the graph plug-in to it.
-
Add a material and/or a texture to the group, or open the graph editor and enable Use Vertexcolor and set the Line Color.
-
Open the graph editor and set the Start and End points.
-
Enable 3D and set Extrusion Depth to 30.0.
-
Add points for the X- and Y-directions (i.e. X0/Y0, X1/Y1 and so on).