Viz Vectar User Guide

Version 1.0 | Published May 07, 2020 ©

Headphones

By default, headphones connected to the ¼” stereo Phones jack carry the first two channels of the audio signal from the bus designated Master 1 – that is, the same audio carried by analog output connectors marked as Ch. 1 and Ch.2 in the OUT 1 group on the system’s backplane.

The Headphone output is also affected by Solo switches located at the bottom of each control group in the Audio Mixer. When Solo is enabled for one or more sources (or outputs) only the soloed sources are sent to the connector (see Common Controls for more information on this feature).