Viz Plug-ins User Guide

Version 5.0 | Published December 20, 2022 ©


The Torus plug-in creates a torus with different attributes.

Note: This plug-in is located in: Plugins -> Geom plug-ins -> Default

Torus Properties

  • Use LOD: Enables/disables dynamic level of detail.

  • Tesselation: Sets the degree of detail for the torus.

  • Corners: Sets the number of corners on the torus.

  • Radius: Sets the radius of the torus from its center in the middle of the hole.

  • Radius cross section: Sets the radius of the torus cross section or “tube”.

To Create a Torus


  1. Create a new group and add the Torus plug-in to it.

  2. Open the Torus editor and set the following parameters:

    • Set Radius to 50.0.

    • Set Radius cross section 20.0.

  3. Add a material and/or a texture to it.