Viz Plug-ins User Guide

Version 5.0 | Published December 20, 2022 ©

Hop It


The Hop It plug-in is a utility plug-in which connects the specific design with a hop. It is used when the designs (e.g. labels, regions etc) were not generated from the hop you want to connect them to (or from no hop at all).

Note: This plug-in is located in: Plugins -> Container plug-ins -> Maps_Adv

Hop It Properties

  • Hop Mode

    • Automatic: Sets hop points automatically (based on searching all hops locations and connecting to the one which is closest).

    • Manual: Sets hop points using the Hop Point parameter.

  • Hop Point: Sets the hop point in the hop sequence. Note that the animation is built in the same sequential order as the list of Hop Points (Map-Start, Destination-1, Destination-2, and so on). If two hops use the same Hop Point, the animation does not work properly.

The three plug-ins that are influenced are Hop Sync, 2D Label and Label It.