Viz Artist
Version 3.11 | Published August 27, 2018 ©
Change Camera Parameters in Orthogonal Views
Camera parameters can be modified in the predefined orthogonal views.
This section contains information on the following procedures:
To View the Predefined Orthogonal Views
-
Click Views.
The camera is shown as an orange circle (3) in the predefined orthogonal views. Two small, green, circular handles (1 and 2) make it possible to modify the position along the X, Y and Z axis of the camera, and also the values for pan and tilt.
To Change the Camera Views
-
Drag handle (1): Change the pan and tilt while the position of the camera stays fixed.
-
Drag handle (2): The camera (3) and handle (1) will be dragged along, so that pan and tilt will not be altered.
-
Drag the camera (3): Change the position of the camera while handle (1) stays fixed. The values for pan and tilt will also change.
See Also