Viz Engine Administrator Guide

Version 5.2 | Published March 20, 2024 ©

Dell R7920

images/download/attachments/120722150/R7920-Bezel.png


Dell R7920 Rack Workstation Slots

images/download/attachments/120722150/dell_r7920_slots.png

Slot

Usage

Slot 1 – PCIe3 x8

Graphics Card only! (Single / Dual Slot)

Slot 2 – PCIe3 x8

Used if a Dual-Slot Graphics Card is installed
Matrox AES Audio

Slot 3 – PCIe3 x8

Video Card (Matrox Video Board)

Slot 4 – PCIe3 x16

Expansion Cards:

Matrox AES Audio
Blue Storm
SeaLevel

Slot 5 – PCIe3 x8

Video Card (Matrox Video Board) (if two Graphics Cards are installed)

Slot 6 – PCIe3 M2 SSD

PCIe M.2 SSD

Slot 7 – PCIe3 x8

Used if a Dual-Slot Graphics Card is installed

Slot 7 – PCIe3 x8

Second Graphics Card

Info: Only newer Matrox Boards like xMio5, xMio3 and DSX.LE4 are supported with Dell R7920 workstations. Older videoboards are not tested by Vizrt.

Default Hardware

  • Rack 2RU

  • CPU: 2x Intel Xeon Silver 4114 (2.2GHz 10-Core) or 2x Intel Xeon Silver 4210R (2.4GHz 10-Core)

  • RAM: 64 GB DDR 4 (8x 8GB)

  • SSD1: 512 GB S-ATA Hot Swap (Operating System)

  • SSD2: 512 GB M.2 NVMe on PCIe Card in Slot 6 (Data and Clips)

  • RAID Controller: Intel SATA/NVMe M.2

  • Power Supply: 2x 1600 W Efficient (Dual GPU configurations require 220V Input for redundancy)

BIOS Settings

  • During Post, press F2 to get access to the BIOS Setup.

    • Click on System BIOS.

    • Click on Processor Settings.

    • Set Logical Processor to DISABLED.

    • Press ESC to Exit Menu.

  • Click on SATA Settings.

    • Set Embedded SATA to RAID MODE.

    • Press ESC to Exit Menu.

  • Click on NVMe Settings.

    • Set NVMe Mode to NonRAID.

    • Press ESC to Exit Menu.

  • Click on Boot Settings.

    • Check if Boot Mode set to UEFI.

    • Press ESC to Exit Menu.

  • Click on Integrated Devices.

    • Set Embedded Video Controller to DISABLED.

    • Press ESC to Exit Menu.

  • Click on System Profile Settings.

    • Set System Profile to Performance.

    • Press ESC twice, Settings are saved.

  • Exit Bios.

  • Press F2 to access BIOS.

  • Click on Boot Settings.

  • Change Boot Order (C should be at top).

  • Save Changes and Exit.

Info: Certain third party vendor drivers require secure boot to be disabled to install properly.