Noggi Properties

• Width: Changes the width in X-direction.

• Height: Changes the height in Y-direction.

• Bevel (top/right, top/left, bottom/left and bottom/right): Changes the bevel on each corner.

• Stretch: The result is an object like a parallelogram. Stretch is in percent (= tan(alpha)). If Geometry Type is Outline.

• Horizontal Alignment: Changes the object alignment to left, center or right. This change affects the y-rotation.

• Vertical Alignment: Changes the object alignment to bottom, middle or top. This change affects the x-rotation.

• Geometry Type: Renders the object as area- or with outline look.

• Inner Outline: Changes the vertex sequence in outline mode. Inner Outline is important for face orientation when extruding the geometry.

• Outline Width: Changes the thickness of the rendered outline.

• Edge Points: Change the number of triangles to render a beveled corner. Increasing the number increases the bevel resolution.

• Crop: Enables/disables cropping of the object. Cropping and vertex texture are only available if Geometry Type is Area.

  • Crop Face (Left, Right, Bottom and Top): Crops the object on each given side.

To Create a Noggi

1. Create a new group and add the Noggi plug-in to it.

2. Add a material and/or a texture to the group.

3. Open the transformation editor and set Position X to -150.0.

4. Open the Noggi editor and set the following parameters:

   • Set Width and Height to 600.0 and 100.0.

   • Set Bevel top/right and bottom/left to 0.0.

   • Set Bevel top/left and bottom/right to 20.0.