The DataGraph plug-in works on the Graph geometry plug-in in Viz. It enables controlling the values of the graph points.
Incoming data values of the DataField must contain all the point values according to the selected format, separated by spaces.
Note: This plug-in is located in: Plugins -> Container plug-ins -> Data
Information: DataPool plug-ins only work properly on a single channel on the same machine.
DataGraph Properties
Format: Defines the axis that is controlled by DataGraph. If one axis is selected (X or Y) then the data should contain one value per point, if X Y is selected, then two values should be sent per point.
Normalize: Forces the graph points to use the entire height range (the range between Position Min and Position Max parameter) according to the minimum and maximum values received when set to
On. The minimum value is used as the Data Min value and the maximum value is used as the Data Max, using the entire graph range for the received values.
Example
If format is set to X Y, then for drawing four point of the graph, eight numbers should be sent: Abc=0 0 10 5 12 10 8 15;
The first point is located at
X=0,Y=0.The second point is located at
X=10,Y=5.The third point is located at
X=12,Y=10.The fourth point is located at
X=8,Y=15.